C20A8 BMW Fault Code

Description:

The Camshaft Position sensor will signal the Engine Control Module when the #1 cylinder is ready for the spark plug to fire (top-dead-center on compression stroke).

The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.

C20A8 Code Symptoms :

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. C20A8 code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing C20A8

C20A8 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to fix C20A8 code ?

• Exhaust gas leaks
• Faulty spark plug (s)
• Ignition coils harness is open or shorted
• Loss of ground.

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code C20A8, so consult the manual to locate the brake fluid reservoir.

Bear in mind that a low fluid level can set code C20A8 on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.